Doosan Infracore D18NAP — General Information

9. Fuel System Fuel injection pump General Information Fuel high-pressure pump uses a radial piston pump Solenoid valve switching (open/close) is operated by high pressure and high current. Based on the values to generate high pressure in fuel. Pressure is set in the ECU, the solenoid valve of the injector is independently generated as fuel is injected. The RPM sequentially operated. The crankshaft sensor and the of the fuel high-pressure pump is directly connected to the engine rotation speed regardless of the rotation camshaft sensor use to detect the engine rev count for starting fuel injection and adjusting the injection ratio of the transmission. Comparing to the existing timing.

injection system, the common rail injection system shows the consistent fuel delivery amount. The fuel high pressure pump pressurizes fuel at the pressure of 1,800 bar and the pressurized fuel is The injector is connected to the common rail with the delivered to the common rail through the high- pressure line. high-pressure pipe. It consists of a nozzle and a solenoid valve. When a key switch is operated, actuating power is supplied to the solenoid valve by The fuel high-pressure pump consists of the following the ECU. When the key switch is blocked, the solenoid valve ends injection. components. 2 1 5 4 3 EDL022169A 1. High pressure fuel line outlet 3. Low pressure fuel line inlet 5.

Drive shaft 2. High pressure fuel line return inlet 4. Low pressure fuel line outlet 9 - 17