9. Fuel System 1. Functions 4. Fuel supply collection 1) The fuel high pressure pump has two pressure phase processes: low-pressure phase and high- pressure phase. Under all operating conditions, it transfers high-pressure fuel in a vehicle for the entire service lifetime. In addition, it delivers fuel required to respond to the rapidly-changing pressure in the common rail or quick start of a vehicle. The fuel high pressure pump continuously generates the system pressure necessary for the common rail. 1) The fuel high pressure pump is designed to deliver a lot of fuel.
While the engine runs at idle or partial load, the fuel excessively delivered returns to the fuel tank through the pressure adjustment valve. Disassembly of Fuel Injection Pump 1. Remove the fuel injection pump (A). 2. Configuration of fuel high pressure pump 1) Inside of the fuel high pressure pump, there are three pump pistons and the pistons are installed with 120, compressing fuel to the circumferential direction. Compression strokes occur three times per rotation. Therefore, consistent stress is kept in the pump driving apparatus and low driving force is required. Pump driving force of the common rail requires about 1/9 of that of the existing pump system. A 3.
Operation method B 1) The fuel delivery pump delivers fuel from the fuel tank to the fuel high pressure pump through the fuel inlet and the safety valve. Then the fuel high pressure pump pumps and the transfers the fuel to the lubricating and cooling circuit of the high pressure pump through the safety valve. The driving shaft, which has the eccentric cam, moves the pump piston up and down according to the cam shape. 2) When the transfer pressure of the fuel delivery pump exceeds the open pressure of the safety valve, the fuel is transferred to the intake stroke position of the pumping chamber where the pump piston moves up and down through the intake valve of the fuel high pressure pump.
When the pump piston exceeds the bottom dead point, the valve inlet is closed and fuel cannot be transferred from the pumping chamber. So the fuel is compressed over the delivered pressure. 3) As soon as the fuel pressure reaches the common rail pressure, the outlet valve is opened. Then the compressed fuel flows into the high pressure circuit. The pump piston continuously transfers fuel until it reaches the bottom dead point. After the bottom dead point is reached, the outlet valve is closed. The fuel in the pumping chamber is relaxed and then the pump piston moves down again.
When the pressure in the pumping chamber is lower than the pressure of the fuel delivery pump, the inlet valve is opened again and the above procedure is started again. EDL022043A F G E D C EDL022043B 1) Loosen 3 flange hex nuts (B). 2) Remove the fuel injection pump (A). 3) Loosen the flange hex nut (C). 4) Remove the injection pump drive gear (D). 5) Remove the collar (F). 6) Remove the O- ring (E) from the collar (F). 7) Remove the O- ring (D). CAUTION Do not reuse the O-ring; replace with a new one. Reuse of the O-ring may cause critical damage to engine performance to occur. 9 - 18