9. Fuel System Assembly of Fuel Injection Pump 1. Attach the fuel injection pump (A). G F E C D EDL022043B A B EDL022043A 1) Mount the O - ring (D). 2) Mount the O - ring (E) to the collar (F). 3) Mount the collar (F). 4) Be careful to mount the injection pump drive gear (D) with attention to the pin direction. CAUTION Ensure that you are attaching the injection pump drive gear so that its engraving faces the outside of the cylinder block. Ensure that the pin direction is the opposite direction of the idle gear. 5) Tighten the flange hex nuts (C) at a tightening torque of 6.5 ± 0.5 kgf•m. 6) Attach the fuel injection pump (A).
Note) To replace stud bolts, apply LOCTITE 272 to the stud bolts and then press in those bolts. 7) Tighten 3 flange hex nuts (B) at a tightening torque of 2.2 kgf•m. 9 - 19