10. Intake/Exhaust System 1) Attach the common rail (A) to the intake manifold. Be careful to note the direction when attaching the gasket. Be careful not to damage the gasket while attaching it. CAUTION Be careful to note the direction when attching the common rail. Be careful not to damage the common rail while attaching it. 2) Tighten 3 flange hex bolts (B) at a tightening torque of 2.2 kgf m. 2) Temporarily tighten 2 collared hex bolts (B) by 3) Attach the boost pressure sensor (C). 4) Tighten the flange hex bolt (D) at a tightening hand. torque of 1.0 kgf m. 3) Temporarily connect the fuel injection pipes (C) . and (D) by hand. 5. Attach the EGR connection pipes.
CAUTION A Do not bend the fuel injection pipes by force. Be careful to note the direction when connecting the fuel injection pipes. Assemble the nut on one side of the fuel injection pipe first, and then the nut on the other side to connect the round part of the pipe to the correspondent part correctly. Do not reuse fuel injection pipes but replace them with new ones. Reusing fuel injection pipes may allow foreign substances into the fuel pipes or oil leaks from the bolt clamping to occur, causing a critical fault in engine performance. B 4) Tighten 2 collared hex bolts(B) at a tightening torque of 2.2 kgf•m.
EDL013004A 5) Tighten the fuel injection pipes (C) and (D) at a 1) Attach 4 gaskets. 2) Attach the EGR pipes (A). tightening torque of 3.0 kgf•m. CAUTION 6) Tighten the fixing bolt (E). Be careful to note the direction when attaching the the EGR connection pipe. Be careful not to damage the gasket while attaching it. 4. Attach the intake stake. C 3) Tighten 6 fixing bolts(B) at a tightening torque of D 2.2 kgf m. A B EDL013005A 1) Attach the gasket and the intake stake (A). CAUTION 10 - 7