Doosan Infracore D18NAP — Assembly of Intake Manifold

10. Intake/Exhaust System CAUTION CAUTION Oil in the filter may run down while removing the oil filter. Be careful not to contaminate the other parts by using a cloth when removing the filter. After replacing the oil filter, wipe clean any other parts which the oil has touced. Be careful to note the direction when mounting the gasket. Be careful not to damage the gasket while mounting it. 2) Tighten 8 flange hex bolts (B) at a tightening torque of 2.2 kgf m. 3) Attach the boost temperature sensor (C). 5. Remove the intake manifold. 2. Attach the oil filter assembly. B D C A C A B EDL013010A 1) Remove the boost temperature sensor (C). EDL01300 9 A 2) Loosen 8 flrange hex bolts (B).

1) Attach the 3 O-rings and the oil filter assembly (A). 3) Remove the gasket and the intake manifold (A) from the cylinder block. 2) Tighten 5 flange hex bolts (B). 3) Connect the coolant hose (C) 4) Tighten the fixing bolt (D). Assembly of Intake Manifold CAUTION 1. Attach the intake manifold. Make sure that the O-rings have been mounted. Be careful not to damage the O-rings while mounting them. 3. Attach the common rail and the injection pipe. B C C A A B E D EDL013010A 1) Attach the gasket and the intake manifold (A). EDL013006A 10 - 6