11. Cylinder block/head Cylinder Block Disassembly of cylinder block Note)Refer to Chapter 6 (Procedure of Disassembling an Engine) 1. Detach the cylinder block. B C A Check of Cylinder Block 1. Cleanse the cylinder block and check if there is any cracked or damaged part with naked eye. D 2. Replace the cylinder block if it is seriously cracked or damaged. Repair tiny cracks if existing. 3. Check if the oil path or coolant path is clogged or EDL013083A corroded. 4. Perform the hydrostatic test to check whether 1) For 4ea main bearings (D) of the cylinder block, measure 8 points of the bearings: front and rear.
2) Measure three (A, B, and C) points of the main bearing part of the cylinder block. 3) The standard measurement value of the inside diameter of the main bearing bore of the cylinder block is within the range of 62.0 ~ 62.021 mm. 5. Block the discharging outlets of the cooling water there is a crank or an air leakage. path and the oil path of the cylinder block and put pressure of 4 kg/cm 2 on the inlet. Then sink the cylinder block in the 70 °C water for 1 minute and check if air leaks. Measurement of Inside Diameter of Main Bearing Bore of Cylinder Block 1. Assemble the cylinder block and the crank case. Measurement of Inside Diameter of Piston Bore of Cylinder Block 2. Set the gauge. 3.
Remove the foreign substances from the main 1. Set the gauge. 4. Measure the inside diameter of the main bearing bearing bore of the cylinder block. 2. Remove the foreign substances from the piston bore of the cylinder block. bore of the cylinder block. 3. Measure the inside diameter of the piston bore of the cylinder block. EDL022204A EDL013084A 11 - 5 Item Specified Value Cylinder Block Inside diameter of main beari 62.0 ~ ng bore 62.021 mm