Doosan Infracore D18NAP — Assembly of Cylinder Block

11. Cylinder block/head B 10 mm 66 mm 120 mm A A B C D EDL013085A EDL013086A 1) For 3ea piston bores of the cylinder block, measure total 9 points of the piston bores: top, 1) For 3ea of the cylinder block, measure total 6 points of the camshaft bores: front and rear. middle, and bottom. 2) Measure 2 points of A and B on the piston bore of the cylinder block. 2) Measure 3 points (A, B, and C) of camshaft bearing shells of the cylinder block. 3) The standard measurement value of the inside diameter of the piston bore of the cylinder block is within the range of 89.990 ~ 90.010 mm.

3) The standard measurement value of the inside diameter of the camshaft bearing of the cylinder block is within the range of 45.0 ~ 45.025 mm. Item Specified Value Cylinder Block Piston bore inside diameter 89.990 ~ 90.010 mm Measurement of Inside Diameter of Camshaft Assembly of Cylinder Block Bearing of Cylinder Block 1. Attach the cylinder block. 1. Set the gauge. Note)Refer to Chapter 6 (Procedure of Assembling an Engine) 2. Remove the foreign substances from the camshaft bearing shell of the cylinder block. 3. Measure the inside diameter of the camshaft bearing of the cylinder block. EDL022088A 11 - 6 Item Specified Value Cylinder Block Camshaft bearing inside diameter 45.0 ~ 45.025 mm