11. Cylinder block/head 2) Mount the front oil seal (E) to the front oil seal 9) Attach the crank speed sensor (C). 10) Tighten the fixing bolt (D). assembly jig (860104-02047). 3) Align the front oil seal assembly jig (860104- 02047) where the front oil seal (E) is mounted to 2. Attach the crankshaft pulley. the timing gear case (A) and beat it with a rubber hammer. 4) when the front oil seal (E) is inserted to the timing gear case(A), pull off the front oil seal assembly jig A (860104-02047). CAUTION Be careful in noting the direction of the oil seal assembly and ensuring that the oil seal surface fasces the outside of the engine.
B Be careful of the depth of the oil seal when attaching it. Be careful not to damage the oil seal. Attach the oil seal without applying lubrication. coolant, fuel, LOCTITE, or silicon. EDL013033A 1) Align the crankshaft pulley (A) to the pin and CAUTION attach it. Remove foreign substances such as residues and LOCTITE from the oil seal assembly bore. 2) Apply LOCTITE Blue 587 to the inside of the 3) Tighten flange hex bolts (B) at a tightening torque flange hex bolts (B). Do not reuse the oil seal; replace it with a new one. of 26 kgf m. Be careful not to damage the oil seal when attaching it. CAUTION Be careful not to damage the oil seal.
5) Remove the foreign substances on the timing gear case assembly surface and clean it with a dry cloth. 6) Apply LOCTITE 5902 to the timing gear case Fix the crankshaft to allow the flange hex bolts to be tightened with the specified torque. assembly surface (F) with the diameter of ш 2.5 ± 0.5mm. 3. Attach the V-belt. CAUTION Keep clean liquid gasket dispensing surface. Dispensing line should not be snapped. 7) Align the timing gear case (A) with the pin and attach it. CAUTION Be careful that the timing gear case has been attached in the right direction. Assemble the timing gear case in 5 minutes after dispensing liquid gasket.
Do not pressureize inside the timing gear case in 25 minutes after dispensing liquid gasket. 8) Tighten 16 hex bolts (B) at a tightening torque of 2.2kgf m. 11 - 8