11. Cylinder block/head 3. Attach the right and left cylinder head cover. CAUTION A Fix the handle of hose clip to face the front of the engine. B C 3) Tighten the fixing bolt (C). D 5. Attach the common rail and the injection pipe. C A B EDL013025A E 1) Attach the left cylinder head cover(A). D 2) Tighten 10 flange hex bolts (B) at a tightening 3) Attach the right cylinder head cover (C). torque of 1.0 kgf m. 4) Tighten 8 flange hex bolts (D) at a tightening torque of 1.0 kgf m. EDL013006A 4. Connect the fuel return hose. 1) Attach the common rail (A) to the intake manifold. CAUTION B Be careful to note the direction when attching the common rail.
Be careful not to damage the common rail while attaching it. A C 2) Temporarily tighten 2 collared hex bolts (B) by B hand. 3) Temporarily connect the fuel injection pipes (C) and (D) by hand. . CAUTION EDL013022A Do not bend the fuel injection pipes by force. Be careful to note the direction when connecting the fuel injection pipes. Assemble the nut on one side of the fuel injection pipe first, and then the nut on the other side to connect the round part of the pipe to the correspondent part correctly. Do not reuse fuel injection pipes but replace them with new ones.
Reusing fuel injection pipes may allow foreign substances into the fuel pipes or oil leaks from the bolt clamping to occur, causing a critical fault in engine performance. 1) Press the fuel return hose (A) into the end of the nipple and connect it. CAUTION Be careful to note the direction when connecting the fuel return hose. The injector should be fully connected with the hose. 2) Attah the hose clips (B). 4) Tighten 2 collared hex bolts(B) at a tightening torque of 2.2 kgf•m. 11 - 14