11. Cylinder block/head Assembly of Cylinder Head Cover 2. Attach the injectiors. 1. Attach the cylinder head cover. A B D B C A EDL013026A EDL013027A 1) Align the injector seal ring washer (A) with the center of the injector hole and mount it. 3 10 8 2 2) Sufficiently apply engine oil on the cylinder head cover surface where the injectors contact. 3) Attach 3 injectors (B). CAUTION 5 6 Do not reuse the head cover rubber seal and the injector oil seal but replace with new ones. Attach injectors by slowly turning them to prevent damage to the cylinder head cover surface which contacts the injectors. 4 9 7 1 Do not reuse the injector seal ring washers.
Otherwise, critical damage to the engine may occur because of unstable combustion. EDL013058A 1) Attach the cylinder head cover (A). 4) Mount 3 injector fixtures (C). 2) Temporarily tighten 10 hex bolts (B) in the order of 5) Temporarily tighten 3 hex bolts (D). 3) Tighten 10 hex bolts (B) at a tightening torque of (1) ~ (10). CAUTION 1.0 kgf m. Do not tighten the hex bolts by force when it is difficult to tighten them temporarily. Forced tightening may cause damage to the cylinder head. CAUTION Be careful not to allow the seal ring of the cylinder head cover to get out to the outside. 6) Tighten 3 hex bolts (D) at a tightening torque of 3.5 kgf m.
Tighten the hex bolts of the cylinder head cover in the order from (1) ~ (10). The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. 11 - 13