11. Cylinder block/head Adjustment of Valve Gap 2. Adjust the valve gap in the following order. 1. Adjust the valve gap. B A 1) Check and adjust the following valve gaps when the #1 cylinder is at the top dead point. #1 cylinder: Intake and exhaust valve #2 cylinder: Exhaust valve #3 cylinder: Intake valve 2) Rotate a full 360° 3) Check and adjust the following valve gap. #2 cylinder: Intake valve #3 cylinder: Exhaust valve EDL032822A 3. Perform the final check after adjusting the gap. 1) Compare the height of the adjust screw of the intake valve to that of the exhaust valve after adjusting the gap by using the adjust screw. 2) If the difference is 2 pitches or more, check the following.
D C Check the assembly state between the push rod and the valve tappet. Check the assembly state between the caliper and the valve. Check of Rocker Arm Shaft 1. Remove the rocker arm shaft. EDL032823A 1) Remove the left and right cylinder head cover. 2) Check the valve gap between the caliper (A) and 3) Loosen the hex nut (C) and tighten the adjust the adjust screw cap (B) with the gap gauge. screw (D) to adjust the valve gap. 4) Check the valve gap between the caliper (A) and 5) The intake valve gap is 0.4 mm and the exhaust the adjust screw cap (B) with the gap gauge. valve gap is 0.45 mm. EDL013089A 1) Loosen and remove the fixing bolts from the rocker arm bracket.
2) Remove the rocker arm bracket, the rocker arm shaft spring, the rocker arm, and the rocker arm shaft in the order as listed before. 2. Check warpage of the rocker arm shaft. 11 - 23 CYL. No # 1 # 2 # 3 Rotation angle IN EX IN EX IN EX TDC (#1 CYL.) ● ● ● ● 360° Rotation ● ● Item Sp ecified Value Intake valve gap 0.4 mm Exhaust valve gap 0.45 mm