11. Cylinder block/head EDL022101A EDL013089A 1) Put the rocker arm shaft on two V-blocks. 1) Loosen and remove the fixing bolts from the 2) Install the dial gauge. 3) Check the degree of warpage of the rocker arm shaft as rotating the rocker arm shaft. rocker arm bracket. 2) Remove the rocker arm bracket, the rocker arm shaft spring, and the rocker arm in the order as Note)If the warpage is slight, correct it by pressing with the press. If the warpage is out of the allowable limit, replace it with a new one. listed before. 2. Check the exterior of the rocker arm with the naked eye. 3. Check the outside diameter of the rocker arm 1) Check whether the adjust screw cap assembly shaft.
surface, which moves as contacting to the valve stem, is scratched, or the layer is worn with the naked eye. Note)If the wear is slight, polish it with the oil-contained whetstone or fine sandpaper. If the layer is seriously worn, replace the rocker arm with a new one. Note)For polishing the rocker arm, use the sandpaper dipped in oil 3. Measure the inside diameter of the rocker arm. EDL013090A 1) Measure the outside diameter of the rocker arm shaft on the position where the rocker arm is attached with the outside diameter micrometer. A Note)If the outside diameter is out of the allowable limit, replace it with a new one. Check of Rocker Arm 1. Remove the rocker arm.
EDL022103A 1) Measure the rocker arm inside diameter with the micrometer or the vernier calipers. 11 - 24