Doosan Infracore D18NAP — Assembly of Rocker Arm

11. Cylinder block/head Note)Compare the measurement value with the outside diameter of the rocker arm shaft. If the gap is larger than the specified value, replace the one of which wear is more serious. 3 10 8 2 Assembly of Rocker Arm 5 1. Attach the rocker arm. 6 B 4 9 7 1 EDL013058A A 1) Attach the cylinder head cover (A). 2) Temporarily tighten 10 hex bolts (B) in the order of (1) ~ (10). 3) Tighten 10 hex bolts (B) at a tightening torque of 1.0 kgf m. CAUTION EDL013028A Be careful not to allow the seal ring of the cylinder head cover to get out to the outside. 1) Attach the rocker arm (A). 2) Tighten 8 flange hex bolts (B) at a tightening torque of 2.2 ± 0.3 kgf m.

Tighten the hex bolts of the cylinder head cover in the order from (1) ~ (10). The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. 2. Attach the cylinder head cover. Do not reuse the cylinder head rubber gasket but replace with new one. A 3. Attach the injectiors. B B D EDL013027A C A EDL013026A 1) Align the injector seal ring washer (A) with the center of the injector hole and mount it. 11 - 25