Doosan Infracore D18NAP — Assembly of Rocker Arm

11. Cylinder block/head 2) Sufficiently apply engine oil on the cylinder head 5. Connect the fuel return hose. cover surface where the injectors contact. B 3) Attach 3 injectors (B). CAUTION A Do not reuse the head cover rubber seal and the injector oil seal but replace with new ones. C Attach injectors by slowly turning them to prevent damage to the cylinder head cover surface which contacts the injectors. B Do not reuse the injector seal ring washers. Otherwise, critical damage to the engine may occur because of unstable combustion. 4) Mount 3 injector fixtures (C). 5) Temporarily tighten 3 hex bolts (D).

EDL013022A CAUTION 1) Press the fuel return hose (A) into the end of the nipple and connect it. Do not tighten the hex bolts by force when it is difficult to tighten them temporarily. Forced tightening may cause damage to the cylinder head. CAUTION Be careful to note the direction when connecting the fuel return hose. 6) Tighten 3 hex bolts (D) at a tightening torque of 3.5 kgf m. The injector should be fully connected with the hose. 4. Attach the right and left cylinder head cover. 2) Attah the hose clips (B). CAUTION A Fix the handle of hose clip to face the front of the engine. B C 3) Tighten the fixing bolt (C). D 6. Attach the common rail and the injection pipe.

C A EDL013025A B 1) Attach the left cylinder head cover(A). 2) Tighten 10 flange hex bolts (B) at a tightening E torque of 1.0 kgf m. D 3) Attach the right cylinder head cover (C). 4) Tighten 8 flange hex bolts (D) at a tightening torque of 1.0 kgf m. EDL013006A 1) Attach the common rail (A) to the intake manifold. 11 - 26