Doosan Infracore D18NAP — Disassembly of Push Rod

11. Cylinder block/head Valve Tappet and Push Rod 3. Measure the outside diameter of the valve tappet. Disassembly of Valve Tappet Note)Refer to Chapter 6 (Procedure of Disassembling an Engine) 1. Detach the valve tappet. Check of Valve Tappet 1. Check the exterior of the valve tappet with naked eye. EDL022105A Normal Abnormal Abnormal 1) Measure the outside diameter of the valve tappet with the outside diameter micrometer. (Embossment) (Crack) Note)If the diameter is out of the allowable limit, replace the valve tappet with a new one. Abnormal Abnormal Assembly of Valve Tappet 1. Attach the valve tappet.

EDL0213006B Note)Refer to Chapter 6 (Procedure of Assembling an Engine) 1) Check whether the valve tappet surface, which moves as contacting to the camshaft, is cracked or scratched. Disassembly of Push Rod Note)If the wear is slight, polish it with the oil-contained whetstone or fine sandpaper. If the crack or scratch is serious, replace the valve tappet with a new one. 1. Remove the breather hose. 1 Note)For polishing the camshaft, use the sandpaper dipped in oil. 2. Measure the gap of the valve tappet. A 1) Measure the outside diameter of the valve tappet and the tappet hole diameter of the cylinder block.

Note)If the diameter is out of the allowable limit, replace the valve tappet with a new one. EDL013001A 11 - 28