Doosan Infracore D18NAP — Disassembly of Push Rod

11. Cylinder block/head 3. Remove the fuel return hose. 2 A B A C B EDL013002A 1) Remove the breather hose (A). EDL013022A CAUTION 1) Loosen the flange hex bolts (C). 2) Remove the hose clips and disconnect the fuel Do not reuse the clamps but replace with new ones. hose (A). 4. Remove the right and left cylinder head cover. 2. Remove the common rail and the injection pipes. A C A B C B D E D EDL013006A EDL013025A 1) Loosen the fixing bolt (E). 2) Loosen the nuts of the fuel injection pipes. 1) Loosen 8 flange hex bolts (D). 2) Remove the right cylinder head cover (C). 3) Loosen 10 flange hex bolts (B). 3) Remove 4 fuel injection pipes (C) and (D). 4) Remove the left cylinder head cover (A).

CAUTION Do not reuse fuel injection pipes; replace them with new ones. If fuel injection pipes are reused it may allow foreign substances into the fuel pipes or cause oil leaks from bolt clamping and cause a critical fault in engine performance. 4) Loosen 2 collared hex bolts (B) of the common rail. Remove the common rail (A) from the intake manifold. 11 - 29