Doosan Infracore D18NAP — Assembly of Push Rod

11. Cylinder block/head 3. Attach the cylinder head cover. 4. Attach the injectiors. A B B D C A EDL013027A EDL013026A 1) Align the injector seal ring washer (A) with the 3 10 8 2 center of the injector hole and mount it. 2) Sufficiently apply engine oil on the cylinder head cover surface where the injectors contact. 3) Attach 3 injectors (B). 5 CAUTION 6 Do not reuse the head cover rubber seal and the injector oil seal but replace with new ones. Attach injectors by slowly turning them to prevent damage to the cylinder head cover surface which contacts the injectors. 4 9 7 1 Do not reuse the injector seal ring washers.

Otherwise, critical damage to the engine may occur because of unstable combustion. EDL013058A 1) Attach the cylinder head cover (A). 2) Temporarily tighten 10 hex bolts (B) in the order of 4) Mount 3 injector fixtures (C). 3) Tighten 10 hex bolts (B) at a tightening torque of (1) ~ (10). 5) Temporarily tighten 3 hex bolts (D). 1.0 kgf m. CAUTION CAUTION Do not tighten the hex bolts by force when it is difficult to tighten them temporarily. Forced tightening may cause damage to the cylinder head. Be careful not to allow the seal ring of the cylinder head cover to get out to the outside.

6) Tighten 3 hex bolts (D) at a tightening torque of Tighten the hex bolts of the cylinder head cover in the order from (1) ~ (10). The front engine direction is the water pump direction and the rear engine direction is the flywheel direction. 3.5 kgf m. 11 - 32