Doosan Infracore D18NAP — Assembly of Push Rod

11. Cylinder block/head 8. Remove the push rods. Assembly of Push Rod 1. Attach the push rods. A A EDL013029A 1) Remove 6 push rods (A). EDL013029A 1) Apply engine oil on both ends of the push rods. Check of Warpage of Push Rod 2) Attach the push rods(A) in the cylinder head holes. 1. Check warpage of the push rod. 3) Hit the head of the push rods with a rubber hammer lightly once or twice to get them positioned in the tappet holes. CAUTION After connecting the push rods, rotate them to check the connection state. 2. Attach the rocker arm. Gap gauge B EDL0213007A 1) Put the push rod on the surface plate. 2) Measure the warped degree with the gap gauge as rolling the push rod.

A Item Specified Value Warpage of push rod 0.5 mm EDL013028A 1) Attach the rocker arm (A). 2) Tighten 8 flange hex bolts (B) at a tightening torque of 2.2 ± 0.3 kgf m. 11 - 31