11. Cylinder block/head Camshaft 3. Measure the outside diameter of the camshaft Disassembly of Camshaft journal. Note)Refer to Chapter 6 (Procedure of Disassembling an Engine) 1. Detach the camshaft. 2. Remove the camshaft gear (A). D A B EDL013092A C 1) For 3ea camshaft journals, measure total 6 points 2) Measure 2 points (vertical and horizontal) of the of the outside diameters: front and rear. outside diameters of the camshaft journals. EDL013091A 3) The standard measurement value of the outside 2) Remove the camshaft gear (A) and the thrust 1) Heat the camshaft gear (A) at 180 °C ± 10 °C. diameter of the camshaft journal is within the range of 44.950 ~ 44.966 mm.
washer (C) from the camshaft (B). CAUTION NEVER let the camshaft gear heat to a temperature exceeding 200 °C. Note)If the outside diameter is out of the allowable limit, replace the camshaft with a new one. Note)Check whether the camshaft surface is cracked or scratched. Measurement of Camshaft Journal Outside Diameter Note)If the wear is slight, polish it with the oil-contained whetstone or fine sandpaper. If the crack or scratch is serious, replace the camshaft with a new one. 1. Set the gauge. 2. Remove foreign substances from the camshaft. Note)For polishing the camshaft, use the sandpaper dipped in oil. 11 - 35 Item Specified Value Camshaft journal 44.950 ~ 44.966 mm