Doosan Infracore D18NAP — Assembly of Camshaft

11. Cylinder block/head Measurement of Camshaft Assembly of Camshaft 1. Check the camshaft offset. 1. Mount the cam gear (A). D A B Gap gauge C EDL021300 3 A EDL013091A 1) Move the camshaft gear to the opposite side of the 1) Mount the thrust washer (C) on the camshaft (B). cylinder block. 2) Mount the woodruff key (D), heat the cam gear (A) 2) Measure the gap between the thrust washer and the camshaft gear with the gap gauge. press in the camshaft into the cam gear. at the temperature of 180 °C ± 10 °C, and then CAUTION Note)Check if the gap is within the range of 0.1 ~ 0.2 mm. NEVER let the cam gear heat to a temperature exceeding 200 °C. The gear engraving should face outward.

Note)If the offset is too large, replace the thrust washer with a new one. 2. Attach the camshaft. 2. Measure warpage of the camshaft. Note)Refer to Chapter 6 (Procedure of Assembling an Engine) EDL013093A 1) Put the camshaft on two V-blocks. 2) Check the degree of warpage of the camshaft with the dial gauge. Note)If the warpage is out of the allowable limit, replace the camshaft with a new one. 11 - 36 Item Spe cified Value Camshaft offset 0. 1 ~ 0.2 mm