Doosan Infracore D18NAP — Disassembly of Idle Gear

11. Cylinder block/head Idle gear Disassembly of Idle Gear CAUTION 1. Remove the V-belt. Do not reuse the oil seal; replace them with new ones. 2. Remove the crankshaft pulley. 4. Remove the timing wheel. A A B EDL013033A 1) Loosen the flange hex bolt (B). 1) Remove the timing wheel (A). EDL013038A 2) Remove the crankshaft pulley (A). CAUTION 5. Remove the idle gear. Be careful not to damage the oil seal. 3. Remove the timing gear case. A B A C B EDL013040A D E C 1) Loosen 3 flange hex bolts (C). 2) Remove the idle gear shaft (B). 3) Remove the idle gear (A) using remove tap. EDL013037A 1) Loosen the fixing bolt (D). 2) Remove the crank speed sensor (C). 3) Loosen 16 hex bolts (B).

4) Remove the timing gear case (A). 11 - 37