13. Others/Driving System 3. Attach the crankshaft pulley. 5. Measure the diameter of the crankshaft main journal A B EDL013033A 1) Align the crankshaft pulley (A) to the pin and EDL013096A attach it. 1) Measure the diameter of the crankshaft journal 2) Apply LOCTITE Blue 587 to the inside of the flange hex bolts (B). 2) Measure total 20 points of the inside diameter of with the outside diameter micrometer. 3) Tighten flange hex bolts (B) at a tightening torque the idle gear: 5 points of vertical (A), horizontal of 26 kgf m. (B), front (C), and rear (D).
CAUTION 3) The standard measurement value of the diameter of the crankshaft journal is within the range of Be careful not to damage the oil seal. 57.955 ~ 57.970 mm. Fix the crankshaft to allow the flange hex bolts to be tightened with the specified torque. 4. Attach the V-belt. Disassembly of Crankshaft Measurement of Crankshaft Bearing Gap 1. Remove the crankshaft. 1. Mount the crankshaft to the cylinder block. Note)Refer to Chapter 6 (Procedure of Disassembling an Engine) 2. Measure the gap of the crankshaft bearing. Measurement of Crankshaft Main Journal Diameter 1. Check whether there is any cracked or scratched part on the journal and pins of the crankshaft with the naked eye. 2.
Perform the magnetic particle testing or the liquid penetrant testing to check the cracks on the crankshaft. If cracks are found, replace the crankshaft with a new one. 3. Set the gauge. EDL013097A 4. Remove foreign substances from the crankshaft. 13 - 7 Item Specified Value Crankshaft journal diameter 57.955 ~ 57.970 mm