13. Others/Driving System 1) Put the plastic gauges on 5 points on the crankshaft which contact with the crankshaft bearing part. 2) Assemble the crank case at the specified torque and then disassemble it. 3) Check the width of the plastic gauges. 4) The standard measurement value of the gap of the crankshaft bearing is within the range of 0.029 ~ 0.059 mm. 3. Remove the plastic gauges. 5) Remove the plastic gauges. 6) Remove any foreign substances from the cylinder block and the crankshaft. Measurement of Crankshaft Warpage 1. Measure the crankshaft warpage. EDL013098A 1) Put the #1 and #5 main journal of the crankshaft on the V- block.
2) Put the dial gauge on the surface plate and measure the warpage of the crankshaft as spinning the crankshaft. 3) The standard measurement value of the warpage of the crankshaft is 0.02 mm for #2 and #4 and 0.03 mm for #3 based on #1 and #5 main journal. Assembly of Crankshaft 1. Attach the crankshaft. Note)Refer to Chapter 6 (Procedure of Assembling an Engine). 13 - 8 Item Specified Value Crankshaft Bearing Gap 0.029 ~ 0.059 mm