13. Others/Driving System Connecting Rod Disconnection of Connecting Rod 1. Disconnect the connecting rod. Measurement of Connecting rod large-end bore 1. Set the meter. Note)Refer to Chapter 6 (Procedure of Disassembling an Engine). 2. Measure the inside diameter of the large-end of the connecting rod. Measurement of Inside Diameter of Connecting Rod Small-end 1. Set the gauge. 2. Measure the inside diameter of the small end of the connecting rod. EDL022199B B EDL022197B C A D A B E EDL022200B C 1) Measure total 6 points of the inside diameter of the 2) Measure all of 3 connecting rods. connecting rod big-end: A, B, C, front (D), and rear (E).
D 3) The standard measurement value of the inside EDL022198B diameter of the connecting rod big-end is within 1) Measure total 4 points of the inside diameter of the connecting rod small-end: vertical (A), horizontal (B), front (C), and rear (D). 2) Measure all of 3 connecting rods. 3) The standard measurement value of the inside diameter of the connecting rod small-end is within the range of 31.025 ~ 31.038 mm. the range of 57.0 ~ 57.015 mm. CAUTION Connect the connecting rods manually until the head of the connecting rod bolt contacts the bolt bearing surfaces on both sides, and then tighten them at the specified torque.
13 - 9 Item Specified Value Connecting rod large-end bore 57.0 ~ 57.015 mm Item Specified Value Connecting rod small-end bore 31.025 ~ 31.038 mm