Doosan Infracore D18NAP — Assembly of Connecting Rod

13. Others/Driving System Measurement of Gap of Connecting Rod Big-end 1. Mount the crankshaft to the cylinder block. 2. Measure the gap of the connecting rod big-end. EDL013099A 1) Put the plastic gauges on 4 points on the 2) Connect the connecting rods. crankshaft that contacts with the connecting rods. 3) Temporarily connect the connecting rods manually. 4) Tighten the connecting rod bolts at a tightening torque of 2 kgf m + 90 with the angle method. 5) Loosen the connecting rod bolts. 6) Remove the connecting rod cap. 7) Check the width of the plastic gauges. 8) The standard measurement value of the gap of the connecting rod big-end is within the range of 0.026 ~ 0.064 mm. 3.

Remove the plastic gauges. 9) Remove the plastic gauges. 10) Remove any foreign substances from the crankshaft and the connecting rod big-end. Assembly of Connecting Rod 1. Connect the connecting rods. Note)Refer to Chapter 6 (Procedure of Assembling an Engine). 13 - 10 Item Specified Value Gap of Connecting Rod Big- end 0.026 ~ 0.064 mm