Doosan Infracore D18NAP — Check of Gear Backlash

13. Others/Driving System Adjustment of Engine Timing Check of Gear Backlash 1. Remove the timing gear case. 1. Remove the timing gear case. 2. Align the engravings of gears. 2. Check the gear backlash. B C H I A D C A J K F D B G E EDL022137A EDL022138A 1) Position the crankshaft gear engraving mark (E) between the idle gear engravings (B). 1) Check the gear backlash with the gap gauge. 2) The standard backlash between the idle gear (A) Note)You can see one crankshaft gear engraving (G) and two idle gear engravings (F). and the crankshaft gear is 0.087 ~ 0.2 mm.

3) The standard backlash between the oil pump drive Note)Position the idle gear engraving (B) between the camshaft gear engravings (C). 4) The standard backlash between the idle gear and gear and the crankshaft gear (B) is 0.06 ~ 0.259 mm. Note)You can see one idle gear engraving (I) and two camshaft gear engravings (H). the camshaft gear (C) is 0.067 ~ 0.211 mm. 5) The standard backlash between the idle gear and Note)Position the idle gear engraving (B) between the injection pump drive gear engravings (A). the injection pump drive gear (D) is 0.087 ~ 0.2 mm. Note)You can see one idle gear engraving (K) and two injection pump drive gear engravings (J). 3. Mount the timing gear case. 3.

Mount the timing gear case. 13 - 15 Item Specified Value Backlash between the crankshaft gear and the idle gear 0.087 ~ 0.2 mm Backlash between the crankshaft gear and oil pump drive gear 0.06 ~ 0.259 mm Backlash between the idle gear and and the camshaft gear 0.087 ~ 0.211 mm Backlash between the idle gear and and injection pump drive gear 0.087 ~ 0.2 mm