Doosan Infracore D18NAP — Check of Gear Axial Offset

13. Others/Driving System Check of Gear Axial Offset 1. Remove the timing gear case. 2. Check the gear axial offset. 3. Mount the timing gear case. EDL022139A 1) Mount the dial gauge on the cylinder block. 2) Press the crankshaft gear (A) into the cylinder block direction. 3) Perform the zero point adjustment of the dial 4) Pull the crankshaft gear (A) and check the gauge based on the crankshaft gear (A). measured value of the dial gauge. Note)The axial offset of the crankshaft gear is 0.100 ~ 0.300 mm. 5) Press the camshaft gear (B) into the cylinder block 6) Perform the zero point adjustment of the dial direction. gauge based on the camshaft gear (B).

7) Pull the camshaft gear (B) and check the Note)The axial offset of the camshaft gear is 0.1 ~ 0.2 measured value of the dial gauge. mm. 8) Press the idle gear (C) into the cylinder block direction. 9) Perform the zero point adjustment of the dial gauge based on the idle gear (C). 10) Pull the idle gear (C) and manually measured value of the dial gauge. Note)The axial offset of the idle gear is 0.1 ~ 0.2 mm . 13 - 16 Item Specified Value The axial offset of the idle gear 0.100 ~ 0.300 mm The axial offset of the idle gear 0.1 ~ 0.2 mm The axial offset of the idle gear 0.1 ~ 0.2 mm