4. Regular Inspection Regular Inspection Table General Conditions Regular inspection and replacement according to the recommended regular inspection table allows you to maintain the engine with optimum conditions and best performance for a long period and prevent unexpected accidents in advance. ( : Inspection and Adjustment, : Replacement) Note 1) Replenish coolant if required. Note 2) Check coolant every 500 hours to maintain the concentration of antifreeze and additives.
4 - 4 Check Points Daily Inspection interval (x 1,000 hours) 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 Coolant system State of connection between cooler and coolant hose ○ Capacity and state of coolant Note 1) ○ Replace every 1,200 hours Note 2) Cooling fan belt tension ○ Lubrication system Lubricating device and oil leakage ○ Capacity and condition of engine oil ○ ● ● ● ● ● ● ● ● ● ● Engine oil filter ○ ● ● ● ● ● ● ● ● ● ● Fuel system Fuel line and connection unit ○ Fuel volume ○ Water draining from water separator ○ Fuel injection time Inspect and adjust if required Injector Inspect and adjust if required Compression pressure Inspect and adjust if required Intake/Exhaust system Air cleaner ○ Clean and replace if required Throttle body cleaning ○ Intake line and connection unit ○ Exhaust line and connection unit ○ Emission state ○ Cylinder head Intake/Exhaust valve gap state ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ head cover rubber seal ● ● ● ● ● ● ● ● ● ● Cylinder head cover rubber gasket (when adjusting valve gap) ● ● ● ● ● ● ● ● ● ● Electric system Battery charging state ○ Various electric units ○