4. Regular Inspection 5) Assemble the oil filter with the filter wrench at a torque of 16 ~ 20 N m. CAUTION Adding oil which exceeds the upper limit of the oil level gauge may cause engine faults. If you have injected engine oil far over the upper limit of the oil level gauge, drain it until the engine oil level indicates somewhere between the upper and lower limit of the oil level gauge. 3. Add the engine oil. 1 A B EDL013069A 2 A B EDL013070A 2) Disassemble the oil level gauge. 1) Connect the drain plug B at a torque of 3.0 kgf m. 3) Inject genuine oil recommended by Doosan. Note) Inject 1/2 of specified oil and then wait for about 1 minute. Then inject the other 1/2 of oil.
4) Assemble the oil cap A. 5) Assemble the oil level gauge. 6) Remove the engine oil drain container from under the engine. 4. After this, perform the final inspection. 1) Check if engine oil leaks after starting the engine. 2) Start the engine and then stop it when it reaches a normal temperature. 3) Wait for 5 ~ 10 minutes. 4) Check the engine oil level with the oil level gauge. 4 - 9