4. Regular Inspection Coolant The coolant plays an important role in the prevention of overheating and freezing of the engine. However, if the engine is used for a long period, the performance of antifreezing and anticorrosion of the coolant degrades. Maintain the condition of the coolant through daily inspections and periodic replacements. The mixing ratio for the engine coolant is 40 % antifreeze and 3~5 % additives (DCA4) to prevent corrosion. For the water in the coolant, use clean tap water. Periodically check coolant to maintain the concentration of antifreeze and additives.
General Information Checking the Coolant DANGER If the radiator cap is opened to exchange or replenish coolant while the engine is overheated, hot water will spurt out and may cause serious burns. If it is absolutely necessary to open the radiator cap while the engine is overheated, wrap the radiator cap with a cloth and slowly open the cap in two steps until the steam pressure has been released from the inside. After the steam pressure has been completely released, remove the radiator cap. CAUTION 1. Check the position of the supplementary tank.
The recommended mixing ratio allows coolant to prevent corrosion of the engine efficiently and to maintain the best engine performance for a long period. Using contaminated water or unspecified antifreeze or additives may cause critical faults in the cooler. 2. Make sure that the engine and radiator are cooled. 3. If the coolant level indicates between the upper limit and the lower limit on the supplementary tank, it means that the coolant volume is normal. 4. If there is insufficient coolant, replenish it. 5. Open the radiator cap and check the condition of Coolant standards Amount of antifreeze during winter the coolant.
If the coolant cap is contaminated or the coolant concentration is outside the specified insufficient, measure the coolant concentration. If range, exchange the coolant. Measurement of Coolant Concentration Special Tools Capacity of coolant The coolant concentration can be measured as follows. 1. If the engine coolant temperature is within a range of 10 ~ 55°C, drain the coolant and fill half a plastic cup with it. CAUTION When taking out a sample of coolant from the supplementary tank, it is difficult to measure the precise concentration. Always take out sample by opening the drain plug of coolant.
4 - 10 Ambient temperature (°C) Coolant (°C) Antifreeze (%) Above -10 85 15 -10 80 20 -15 73 27 -20 67 33 -25 60 40 -30 56 44 -40 50 50 Figure Product Number/Name C) B) A) 60.99901-0038 CC2602M (Fleet guard number) Coolant test sheet Engine Model and Product Code Coolant capacity ( ℓ) DL01-LEE00 2.7 DL01-LEL00 2.7