Doosan Infracore D18NAP — Measurement of Coolant Concentration

4. Regular Inspection 2. Soak the test sheet in the coolant and take it out after 3 ~ 5 seconds. Shake the sheet to remove the remaining coolant. 3. Wait for about 45 seconds until the test sheet changes its color. CAUTION TEST TEST Measurement time should not exceed 75 seconds. The color changes as time passes. SERVICE SERVICE PRE CHARGE PRE CHARGE 4. Check the color on test sheet. EDL022154A 1) Compare the changed pink color part A of the test sheet with the GLYOOL/FREEZEPOINT (End pad) of the standard color table on top of the container and confirm the concentration. The concentration indication has to be within the color scope of 33~50%.

2) The state of additives for anticorrosion is shown on the point where the color of MOLYBDATE (Middle pad) on the standard color table (which is identical with the Middle (B) of the test sheet) is EDL0213002A crossed with the color of NITRITE on the standard 1) Compare the color of part A on the test sheet to the color of GLYCOL / FREEZEPOINT (End pad) color table (which is identical with the (C) of the test sheet). It should be maintained at the optimum of the standard color table. range, in the green section between 0.3 to 0.8. 2) Compare the color of the test sheet (B) to the color 3) If the measurement result is below 0.3, replenish of MOLYBDATE (Middle pad) of the standard color table.

anticorrosion additives (DCA4). If it is above 0.8 or, drain a little coolant and then inject clean tap 3) Compare the color of the test sheet (C) to the color water to adjust the concentration. of NITRITE of the standard color table. CAUTION 5. Compare and confirm the parts with identical If the color on the test sheet does not match the color of the standard color table, find a middle color on the standard color table. For example, if the color of (C) of the test sheet matches D and F on the NITRITE of the standard color table, select E. colors on the test sheet and the standard color table.

To prevent corrosion inside of the engine cooling unit, drain the coolant and replace it with new coolant once a year. 4 - 11