4. Regular Inspection Replenishment of Coolant Replacement of Coolant If the coolant level of the supplementary tank is below the lower limit, replenish the coolant as follows. 1. Remove the supplementary tank cap. Never open the radiator cap while the engine is overheated. If the radiator cap is opened while the engine is overheated, hot water will spurt out and may cause serious burns. Open the radiator cap after ensuring that the engine has been cooled sufficiently. DANGER 2. Replenish coolant until its level is between the upper and lower limit of the supplementary tank. 3. Install the supplementary tank cap.
CAUTION Mark and separately manage the containers for storing coolant from beverage containers to avoid confusion. If coolant is ingested, see a doctor immediately. Be careful not let foreign substances flow into the engine when replenishing coolant. If there is not coolant in the supplementary tank, replenish the coolant as follows. 1. Remove the radiator cap while the engine and CAUTION radiator are cold. Be careful not to get coolant on any belts or electric apparatus when replacing the coolant. 2. Replenish coolant up to the inlet of the radiator. 1. Make sure that engine and radiator are cooled. 3. After starting the engine let the coolant circulate 2.
Place a container in front of the coolant drain plug. sufficiently and check the coolant level. If there is 3. Remove the radiator cap. 4. Install the supplementary tank cap. insufficient coolant, replenish more. 4. Unplug the coolant drain plug of the radiator and 5. Remove the supplementary tank cap. then drain coolant. 6. Replenish coolant until its level is between the 5. After completing coolant drain, connect the coolant drain plug again. upper and lower limit of the supplementary tank. 6. Drain the coolant from the coolant supplementary CAUTION tank and cleanse the tank. If the radiator cap is opened while the engine is hot, hot water will spurt out and may cause serious burns.
Open the radiator cap after making sure that the engine has been fully cooled. 7. Fill the radiator inlet with water and install radiator Note) Slowly pour coolant in to let the air be discharged from radiator and press the hose connected to it to discharge the air inside. cap. Mark and separately manage the containers for storing coolant from beverage containers for avoiding confusion. See a doctor immediately in case of drinking coolant. 8. Start the engine to let the cooling fan rotate 2 or 3 times. When the engine is warmed up, increase the engine RPM two or three times. 9. Stop engine and wait until engine is cooled. 10. Remove the radiator drain plug and drain water. 11.
Repeat the above mentioned processes from 1 to 8 until the drained water becomes clear. 12. Press the hose connected to the radiator to discharge the air from inside of the radiator and slowly fill the radiator with the coolant at the specified mixing ratio to let the air be discharged from the radiator. Note) Use recommended genuine antifreeze. 4 - 12