4. Regular Inspection CAUTION Do not mix antifreezes from different manufacturers. Do not mix the coolant with different concentrations. Do not add antirust which is not recommended by us. As insufficient coolant concentration may cause corrosion or freezing, on the other hand, an excessive concentration may degrade the cooling performance. Mix coolant with 40% antifreeze and 3~5% additives (DCA4) to prevent corrosion. 13. Operate the engine at idle after starting. When cooling fan is running and coolant is circulated, remove radiator cap and replenish coolant through the inlet. 14. Replenish coolant until the cooling fan rotates 3 ~ 5 times. 15.
Replenish coolant to the upper limit of the supplementary tank and then install radiator cap. 16. Operate the engine at idle until the cooling fan 17. Stop the engine and wait until the engine and the rotates 2 ~ 3 times. radiator are cooled. 18. After checking the coolant level in the supplementary tank, replenish coolant until the tank level stays between the upper and lower limit without changing. Note) After replenishing coolant, check the coolant level of the supplementary tank for at least two or three days. CAUTION After replenishing coolant, check the coolant level of the supplementary tank for at least two or three days.
WARNING Discard exchanged coolant according to the regulations set forth by the relevant authorities. Disposing of exchanged coolant into the ground, sewers, drains, rivers, or the sea will cause serious environmental pollution. Violation of regulations regarding discard of engine oil without observing the handling regulations, will be punished. 4 - 13