Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION 11. Inspect tires. WARNING 12. Inspect rims. WARNING 3 - 70 8. Check for damage to gauges, lamps on the ins trument panel and lo heck for damage to th e panel, gauges and lamps. If any abnormality is found, repl ace the parts. Clean off an y dirt n the surface. Tighten 9. Check rear view mi rror, under view mirror heck for any damage to the mirrors, and if any da mage is f ound, repla ce the mirror . Clean all dirt from the surface f the mirror and adjust the angle so that the view to the rear and below th e machine c an be seen from th e operator's eat. 0. Check for damage to the seat belt and mountin g clamp heck that there is no arts.

abnormality in the seat belt or mounting Check for any loose bolts of the clamps mountin g the equipment to t he machine . Tighten any loose When the belt has b een used for a long time, if a ny external damage or fraying o f the belt can be se en, or i f the clamps are broken o r deformed, replace the sea t belt. ce with new worn or damaged tires ar e used, they may burst and cau se seriou s injury r death. se the following tires. ves of less than 15% of that of a new tire ven wear or with stepped-type wear t has reached the cords, or with cracks in the cords rated) surface ad repaired tubeless tires or abnormally damaged tires, which do not o ensure safety, do not u ear:

Tires with a tread groo ves of less than 15% of that of a new tire Tires with extreme une ven wear or with stepped-type amage: Tires with damage tha rubber Tires with cut or pulled Tires with peeled (sepa Tires with damaged be Leaking or improperly Deteriorated, deformed seem usable heck the rims (wheels) a nd rings for deformation, corro sion and cracks. particular, check the sid e rings, lock rings and rim flan ges thoroughly.