. OPERATION OPERATION STARTING IN COLD WEATHER WARNING Start the engine only after sitting down in the operator's seat. Do not attempt to start the engine by short-circuiting the engine starting 3. When the pre-heating is completed, the pre-heating pilot lamp will go out. 4. When the engine starts, release the key in starting switch (1). The key will return automatically to the ON position. REMARK When starting the engine, the monitor may flash while the starting motor is turning, but if the monitor lamp goes out after the engine is started, there is no abnormality. 3 - 82 circuit. S Check th then sou uch an act may c at there are no p nd the horn and ause a serious bodily injury or fire.
ersons or obstacles in the surrounding area, start the engine. ds as they may cause explosions. Never us e starting aid flui ds as they ma y caus e explosi Exhaust gas is toxic. Whe n starting the engin e in confi ned spaces , be particula rly careful to ens ure good ventilation. NOTICE ccelerate the engine suddenly before completing the warming-up operation. eep the starting motor rotating continuously for more than 20 seconds. gine does not start, wait for at least 2 minutes before trying to start the engine again.
D o not a ccelerate the eng ine suddenly b efore completi ng the warming-up D o not k eep the starting m otor rotating continuously fo r more than 20 If the en gine does not sta rt, wait for at le ast 2 minutes before trying to start If the ac celerator pedal is kept depresse d after starting the engine, the engine speed will sudden ly rise after the turbo protect time, thi s may damage the turbocharger . 1. Turn t he key of startin g switch (1) to the ON pos ition. 2. The pr e-heating will st art automatically a ccording to th e engine water temperature an d the pre-heating pilot lam p will l ight up. The pre-heating times are as shown b elow.
Engine water temperat ure Pre-heating time above - 5°C (23°F) – - 5°C to - 20°C (23°F to - 4°F) 20 to 40 sec below - 20°C (- 4°F) 40 sec