. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 121 BEFORE STORAGE ge (more than one month), store as follows. dried, house the machine in a dry building. Never leave it outdoors. When keeping in long-term stora ge (more than one month), store as follows After every part is washed and dried, house the machine in a dry building . Never lea In case it is indispensable to le ave it outdoors, park the machine on the fla t ground a nd cover it with canvas etc. Completely fill the fuel tank. T his prevents moisture from collecting. efore storage. e hydraulic cylinder piston rod with grease.
Lubricate and change the oil b Coat the exposed portion of th e hydraulic cylinder piston rod with grease. Disconnect the negative termin als of the battery and cover it or remove it fro m the mac hine and store it separately. Apply the parking brake. Set the tire inflation pressure f or each tire to within the range of the specifie d inflation pressure for the type of tire. Push the retarder control leve r forward to the OFF position. e N position and turn the starting switch OFF.
Place the gear shift lever at th e N position and turn the starting switch OF To prevent corrosion, be sure t o fill the cooling system with Supercoolant (A F-NAC) or permanent typ e antifreeze (density between 30% and 68 %). If it is necessary to perform the rust- prevention operation while the machine is indoor s, open the d oors and window s to improve ventilation and prevent gas poisonin Operate the engine and move th e machine for a short distance once a month so that a n ew film of oil wi ll be coated over movable parts and compon ent surfaces.
At the same time, also charge the batter Before operating the work equip ment, wipe off all the grease from hydraulic piston rods NOTICE If the machine has been stored with out carrying out the monthly rust-prevention op eration, con sult your Komats u distributor before using it. When using the machine after lo ng-term storage, do as follows before using Wipe off the grease from the h Add oil and grease at all lubric When the machine is stored for a long period, moisture in the air will mix with the oil. C heck the oil befo re and after starting the engine. If there is water in the oil, change all the oil. PRECAUTIONS BEFORE TRAVELING AFTER LONG-TERM STORAGE 1.
Check all the oil and water le 2. When traveling after long-ter or 1 km to run the machine in 1. Check all the oil and water le 2. When traveling after long-ter m storage, travel forward at a speed of 10 to 15 km/h (6. 2 to 9.3 MPH) fo r 5 minutes , then change to normal travel.