Komatsu — AFTER RUNNING OUT OF FUEL

. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION 1. Remove fuel filter cartridge (1), fill the inside of the filter with clean fuel, taking care not to let dirt or dust get in, then install 3 - 122 AFTER RUNNING OUT OF F UEL When s tarting after running out of f uel, fill with fuel, then bleed the a ir from the fuel system This e ngine consists of higher precis ion parts than on the conventional fu el injection pump and no zzle, so if dirt gets in, it will cause problems. If there is any dirt st uck to the fuel line, use fuel to wash it off completely. Be ca reful when opening the air blee d plug at the fuel filter head and the air bleeder of the suppl y pump.

The system is still under pressure and fuel may spurt o ut. it ag Add ain. fuel from small hole (A) (dirt add If cl fuel from hole (B) (clean sid ean fuel is not available, go 2. Loosen air bleed plug (2) at the 3. Loosen the knob of priming pum p (3), then pump the knob and air bleed plug (2). m (0.8 to 1 kgf·m, 5.8 to 7.2 lbft) pply pump. 90 to 100 times until no more om air bleeder (4), then tighten m (0.5 to 0.7 kgf·m, 3.6 to 5.1 pump (3) becomes stiff. (3) in and tighten it. che ck that fuel comes out from 4. Tighten air bleed plug (2). Tightening torque: 7.8 to 9.8 N· 5. Loosen air bleeder (4) of the su 6. Pum p priming pump (3) approx.

bubbles come out with the fuel fr air bleeder (4). Tightening torque: 4.9 to 6.9 N· lbft) bubbles come out with the fuel fr air bleeder (4). Tightening torque: 4.9 to 6.9 N· 7. Continue pumping until priming 8. Pus h the knob of priming pump 9. Tur n the key in the starting switc h to the START position and start the engine. If the eng ine does not start, repeat the procedure from Step 2.