Komatsu — BLEED AIR FROM FRONT BRAKE

. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM FRONT BRAKE WARNING 4 - 29 Stop the machine on level ground a nd put blocks under the wheels before To make it easier to bleed the ai r, warm the oil up to a temperature of at least 40°C (104°F ) before bleeding the air. 1. Start the engine, check that the oil in the transmission case is the specified level, and check if the retarder oil pressure caution lamp is out. 2. Remove the cap installed to bleeder screw (1) of the slack adjuster, then insert a vinyl hose. Prepare a container with oil in it and insert the other end of the hose approx. 50 mm (2.0 in) below the surface of the oil. (Use any commercially available vinyl hose.) 3.

Depress the brake pedal and loosen bleeder screw (1) approx. 3/4 turns. Keep the pedal depressed until no more bubbles come out from the vinyl hose. 4. Pull the retarder control lever and loosen bleeder screw (1) approx. 3/4 turns. Keep the retarder control lever depressed until no more bubbles come out from the vinyl hose. 5. After bleeding the air, tighten bleeder screw (1) securely and fit the cap. 6. The procedure for bleeder screw (2) of the front brake is the same as for the slack adjuster (with Step 4 excluded). 7. Check that the oil level in the transmission case is up to the specified level. REMARK Bleed the air from the front brakes in the same way on both the left and right sides.

1. Start the engine, check that the oil in the transmission cas e is the specified level, an d check if the retarder oil pressure caution lamp is ou 2. Remove the cap installed t adjuster, then insert a vinyl Prepare a container with oil i hose approx. 50 mm (2.0 in n it and insert the other end of the ) below the surface of the oil. (Use any commercially avai Depress the brake pedal an 3/4 turns. Keep the pedal lable vinyl hose.) d loosen bleeder screw (1) approx. depressed until no more bubbles e. er and loosen bleeder screw (1) come out from the vinyl hos 4. Pull the retarder control lev approx. 3/4 turns. Keep the (1) retarder control lever depressed until no more bubbles come 5.

After bleeding the air, tighten bleeder screw (1) securely an d fit the cap. The procedure for bleeder s 6. same as for the slack adjust 7. Bleed the air from the front brake s in the same way on both the left and