. MAINTENANCE SERVICE PROCEDURE BLEED AIR FROM CENTER BRAKE WARNING 4 - 30 Stop the machine on level grou nd and put blocks under the wh eels before bleeding To make it easier to bleed th e air, warm the oil up to a te mperature of at least 40°C (104°F) b efore bleeding the air. 1. Start the engine, check that the oil in the transmission case is the specified level, and check if the retarder oil pressure caution lamp is out. 2. Remove the cap installed to bleeder screw (1) of the slack adjuster, then insert a vinyl hose. Prepare a container with oil in it and insert the other end of the hose approx. 50 mm (2.0 in) below the surface of the oil. (Use any commercially available vinyl hose.) 3.
Depress the brake pedal and loosen bleeder screw (1) approx. 3/4 turns. Keep the pedal depressed until no more bubbles come out from the vinyl hose. 4. Pull the retarder control lever and loosen bleeder screw (1) approx. 3/4 turns. Keep the retarder control lever depressed until no more bubbles come out from the vinyl hose. 5. After bleeding the air, tighten bleeder screw (1) securely and fit the cap. 6. The procedure for bleeder screw (2) of the center brake is the same as for the slack adjuster (with Step 4 excluded). 7. Check that the oil level in the transmission case is up to the specified level.
REMARK Bleed the air from the center brakes in the same way on both the left and right sides. 1. Start the engine, check that the oil in the transmissio n cas e is the specified level, and c heck if the retarder oil pressure caution lamp i 2. Remove the cap install adjuster, then insert a vi Prepare a container with oil in it and insert the other e nd of the hose approx. 50 mm (2. 0 in) below the surface of the (Use any commercially 3. Depress the brake peda l and loosen bleeder screw (1 ) approx. 3/4 turns. Keep the pe dal depressed until no more bubbles hose. l lever and loosen bleeder screw (1) the retarder control lever depressed come out from the vinyl 4.
Pull the retarder contro (1) approx. 3/4 turns. Keep epressed until no more bubbles c ome out from the vinyl hose. 5. After bleeding the air, tig hten bleeder screw (1) secur ely an d fit the cap. 6. The procedure for bleed er screw (2) of the center bra ke is the same as for the slack a djuster (with Step 4 excluded 7. Bleed the air from the cente r brakes in the same way on both the left