. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR BELT TENSION, ADJUST CHECKING pressed 4 - 42 The deflection shoul d be 13 to 16 mm ( 0.5 to 0.6 in) w midway between the drive pulley and a with the thumb with a force of 98.1 N (1 ADJUSTING ounting bolts (6) (2 places), and r 1. 2. 3. 4. 1. Remove cover m ounting bolts (6) ( cover. 2. Loosen bolts and nuts (1), (2) and (5 ), then turn nut ( the tension of the belt. 3. After adjusting, ti ghten bolts and nu ts (1), (2) and (5 alternator (3). 4. Reinstall the cov er removed in step 1. Confirm tha the cover touche s any moving part of the alternato REMARK Check each pulley for breakage and wear of the V-g roove.
In particular, check that the V-b elt does not touch the bottom of the V-gr oove. is found, ask your Komatsu distributor for replacement of the pulley. engthened that it cannot be adjusted any more or if it has any cuts or cracks, replace it. If any abnormality is found, ask your Komatsu distri If the V-belt is so l engthened that it c annot be adjus ted any more or if it has any cuts or c When adjusting th e V-belt, do not pr ess the alternat or directly with a bar, but put a wood piece, etc. in-between them. If the V-belt has b een replaced with a new part, ther e will be initial elongation, so inspect a nd adjust it again after one-hour of opera tion.