Komatsu — CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING ADJUSTING initial elongation, so adjust the belt again after 4 - 43 The belt should n ormally deflect by 10 mm (0.4 in ) when p ressed with the thumb ( with a force of app rox. 58.8 N (6 kgf)) at a point midway between the air compresso r pulley and drive pulle 1. Loosen bolt ( 2. Turn nut (2) t approx. 10 mm 0.4 in) whe n pressed with th e thumb at a point m idway between the a of approx. 58 ir compressor pull .8 N (6 kgf). Tighten bolt position. 4. Check each p ulley for damage, w ear of the V-groove, an d wear of the V-belt.

I n particular, be sur e to check that the V-be lt is not ouching the bottom of the V-gro 5. I f the V-belt i s so lengthened t hat it canno more or if it h as any cuts or crac ks, replace it. 6. I f the V-belt h as been replaced operating for there wil