Komatsu — CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING LEVEL IN ENGINE OIL PAN, ADD OIL (PAGE 3-72)". 4 - 48 EVERY 500 HOURS SERVI Maintenance for every 50 and 25 0 hours service should be carried out at the same time The parts and oil is at high temperatur e after the engine has been operated, and it can result in a burn . Wait for the oil to cool down before changing it. Refill capacity: 52 liters (13.74 Filter wrench 1. Set a container to catch the o il immediately under the drain valve under the chassis . 2. Remove drain plug (1), then avoid getting oil on yourself, a loosen the drain valve too far a the valve.

Check the drained oil, and particles or foreign material, distributor. 3. 4. Tighten drain valve (2) and dr Tightening torque Drain plug (1), drain plug (2): 5. Using the filter wrench, turn remove it. When doing this, to prevent g out this operation from immed In particular, if this operation stopping the engine, a large a for 10 minutes before starting Tightening torque Drain plug (1), drain plug (2): 5. When doing this, to prevent g out this operation from immed In particular, if this operation stopping the engine, a large a for 10 minutes before starting 6. Clean the filter holder, fill the the packing face and thread w then install the filter cartridge. 7. Install the filter cartridge.

Wh en doing this, be careful not to damage the outside cyl When installing the filter cartri dge, tighten until the packing face is in contact with th e filter holder, then tighten a further 3/4 to 1 turn. 8. 9. Pour in the specified amount Run the engine for a short tim is filled up to a specified leve