. MAINTENANCE SERVICE PROCEDURE LUBRICATE CAB MOUNT PIN (LEFT AND RIGHT: 1 PLACE EACH) pump, pump in grease through the grease CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 51 1. Stop the engi 2. ittings shown 3. After greasin g, wipe off any old g rease that was p ushed ou Th e parts and oil are at high temperatu re after the engine i s stopped , and may c ause s erious burns. W ait for the temperature to go down befo re starting the o peratio If there is still pre ssure remainin g insid e the case, the oil or plug may fly out. Turn the p lug slowly to rele ase the pressure, then remove it carefu 1. Stop the mac hine so that t he TO P casting mark is at the top m.
op and drain plu g (P) is at the botto 2. Remove plug (G) and chec k that t he oil l eve l is near the bottom of the plug ho le. l is low, add axle oil until it overflows from the 3. I f the oil leve plughole. 4. Repeat the pr ocedure in Steps 1 - 3 and check the oil leve l and add oil to all t he final drive cases (front, center, rea r).