. MAINTENANCE SERVICE PROCEDURE tighten the cap. 4 - 50 6. When installing, tig hten until the packing surface contacts the seal surface of the filte r holder, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will le ad to leakage of fuel. If the filter cartridge is to o loose, fuel will also leak from the packing, so always tighten th When tightening with a filter wrench, be extremely careful not to dent or damage 7. Check that the drai n plug at the bottom of the water separator cup is tightened secu Tightening torque: 0.2 to 0.45 N·m (0.02 to 0.046 kgf·m, 0.1 to 0.3 lbft) 8.
When carrying out standard replacemen t of the fuel filter cartridge (every 1000 hours ), replace the cartridge and bleed the air. For details, see "REPLACE FUEL FILTER CARTRIDGE (PAGE 4-5 9. Start the engine, ch eck that there is no l eakage of fuel from the filter seal surface or water separator mounting surface, then run fo r approx. 10 minutes CLEAN FUEL TANK 1. Remove cap (1), th en wash the strainer The strainer forms one unit with the cap 2. After checking and cleaning the strainer,