Komatsu — CHECK TIGHTENING PARTS OF TURBOCHARGER

. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF BRAKE DISC WARNING it depressed, and push in the rod (2) enters beyond guide end limit, please contact your · m · m, 10.8 to 14.5 lbft) CHECK TIGHTENING PARTS OF TURBOCHARGER Contact your Komatsu distributor to have the tightening portions checked. 4 - 63 Carry out this check when the brake oil temperature is below 60°C (140°F). I f the disc wear approaches the wear limit, check the condition frequently, regardless of the maintenance interv al. In addition, check the retarder capacity carefully . 1.

Stop the machine on level grou nd, set the parking brake switch to the PARKING position, then ch eck tha t the other brakes are not applied be fore starting inspection. d check that the retarder oil pressure caution lamp is out. 2. Turn the starting switch ON an d check that the retarder oil pressure caution lam I f the retarder oil pressure cautio n lamp is lighted up, start the engine, run the engin e at 2000 rpm, an d if the lamp goes out, turn the starting switc h OFF. 3. 4. Depress the brake pedal, keep r od (2) of the gauge until conta 5. I f mark (3) at position "A" of ro f I ace (4), it means that the disc f the disc has reached the w Komatsu distributor for inspecti 6.

Tighten cap nut (1) removed in Tightening torque: 14.7 to 19.6 (1.5 to 2.0 k Tightening torque: 14.7 to 19.6 REMARK With new machines, the position of the guide is adjusted so that mark (5) comes t o end face (4) of t he guid e, so d o not loosen locknut (6) except when replacing the disc. workers. One worker depresses the brake pedal and the other pushes in the Carry out the operation with two rod. If the rod is pushed in when the engine is running, the rod will be pushed back by t he brake cooling oil pressure, s o always carry out this operatio n with the engine stopped. ree places (A, B, C), but on this machine, use the mark at position A.

There are marks on the rod at th ree places (A, B, C), but on this machine, use th e mark at position ushes i n the