Komatsu — CHANGE OIL IN FINAL DRIVE CASE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING 4 - 64 EVERY 2000 HOURS SE Maintenance for every 50, 250 , 500 and 1000 hours serv ice should be c arried out at the s The par ts and oil are at high te mperature after the engine is s topped, and may cause s erious burns . Wait for the temperature to go do wn before starting the If there i s still pressure remainin g inside the case, the oil or plu g may fly out. Tu rn the p lug slowly to release the pressure , then remove Refill capacity: Front left, rig ht 6.0 liters (1.59 US gal) ight 4.5 liters (1.19 US gal) ht 6.0 liters (1.59 US gal) 1. Stop the machine so that and d rain plug (P) is at the 2. again 3.

Add a xle oil to the specifie d level through the hole for plug (G). 4. After adding oil, check that the oil is at the specified le vel. See "CHECK OIL LEVEL IN (PAGE 4-51)". FINAL DRIVE CASE, ADD OIL (PAG 5. Repe at the procedure in St eps 1 - 4 and change the oil to all the final d rive cases (front, cen ter, rear).