. MAINTENANCE SERVICE PROCEDURE CLEAN ENGINE BREATHER ELEMENT WARNING CHECK ALTERNATOR, STARTING MOTOR contact your Komatsu distributor for inspection or 4 - 71 The parts and oil are at high temperature after th e engine is stopped, and may cause serious burns. W ait for the temperature to go down before cle aning the engine breather . hat dirt may be blown up and cause serious injury. protective equipment. When using compres sed air, there is a hazard t hat dirt m ay be blown Always use safety gla sses, dust mask, or other protectiv e equipment 1. Wipe off the dirt fr om around the breathe r. . 1). 2. Loosen the clamp , then remove the hose 3. Remove the bolt, then remove breather ( 4.
Rinse the whole b reather in diesel oil or f lushing o 5. After washing, pa arrow. 6. Dry with compres install. Check the eleme parts if necessary ss diesel oil through in the direction of th sed air, then coat the O-ring with oil, an nt and O-ring, and replace them with ne . 7. Check the breath er hose, and if any deteriorated o il is stuck t the inside, replac e the hose with a new h ose. The brush may be wo repair. If the engine is starte d frequently, carry out in spection every 100 CHECK, ADJUST ENGINE VALVE CLEARANC E Special tools are nee ded for the inspection a nd maintenance, s o please contact your Komat su distributor to have this work carried out.
CHECK INJECTOR See Section "A REG ULATION AREA (PAGE CLEAN, CHECK TU Contact your Komats u distributor for cleaning and ins CHECK PLAY OF TURBOCHARGER ROTOR Contact your Komats u distributor to have the rotor pla y checked