Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE Compression Pressure [D1803-M-DI, V2403-M-DI, V2403-M-DI-T] 1. Run the engine until it is warmed up. 2. Stop the engine and disconnect the 2P connector from the stop solenoid in order not to inject fuel. 3. Remove the air cleaner, the muffler and all glow plugs. 4. Set a compression tester (07909-39081) with the adaptor K (07909-31291) to the glow plug hole. 5. While cranking the engine with the starter, measure the compression pressure. 6. Repeat steps 4 through 5 for each cylinder. NOTE Q Check the compression pressure with the specified valve clearance. Always use a fully charged battery for performing this test.

Variances in cylinder compression values should be under 10 %. W1111297 S-22 KiSC issued 07, 2008 A Compression pressure Factory spec. 2.95 to 3.23 MPa 30.0 to 33.0 kgf/cm2 427 to 469 psi Allowable limit 2.35 MPa 24.0 kgf/cm2 341 psi