Kubota — SERVICING

03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE 4. CHECKING, DISASSEMBLING AND SERVICING [1] CHECKING AND ADJUSTING (1) Engine Body Compression Pressure [D1503-M, D1703-M, D1803-M, V2003-M, V2203-M, V2403-M, V2403-M-T] [D1703-M-BG, V2003-M-BG, V2003-M-T-BG, V2203-M-BG, V2403-M-BG] 1. Run the engine until it is warmed up. 2. Stop the engine and disconnect the 2P connector from the stop solenoid in order not to inject fuel. 3. Remove the air cleaner, the muffler and all injection nozzles. 4. Set a compression tester with the adaptor to the nozzle hole. 5. After making sure that the stop lever is set at the stop position (non-injection). 6.

While cranking the engine with the starter, measure the compression pressure. 7. Repeat steps 4 through 6 for each cylinder. 8. If the measurement is below the allowable limit, apply a small amount of oil to the cylinder wall through the nozzle hole and measure the compression pressure again. 9. If the compression pressure is still less than the allowable limit, check the top clearance, valve and cylinder head. 10.If the compression pressure increases after applying oil, check the cylinder wall and piston rings. NOTE Q Check the compression pressure with the specified valve clearance. Always use a fully charged battery for performing this test.

Variances in cylinder compression values should be under 10 %. W1018639 S-21 KiSC issued 07, 2008 A Compression pressure Factory spec. 3.24 to 3.72 MPa 33.0 to 38.0 kgf/cm2 470 to 540 psi Allowable limit 2.55 MPa 26.0 kgf/cm2 370 psi