03-M-E3B, 03-M-DI-E3B, 03-M-E3BG WSM DIESEL ENGINE (2) Lubricating System Engine Oil Pressure 1. Remove the engine oil pressure switch, and set an oil pressure tester (Code No.: 07916-32032). (Adaptor screw size : PT 1/8) 2. Start the engine. After warming up, measure the oil pressure of both idling and rated speeds. 3. If the oil pressure is less than the allowable limit, check the following. Engine oil insufficient. Oil pump defective Oil strainer clogged Oil filter cartridge clogged Oil gallery clogged Excessive oil clearance Foreign matter in the relief valve (When reassembling) After checking the engine oil pressure, tighten the engine oil pressure switch to the specified torque.
(3) Cooling System W1034952 Fan Belt Tension 1. Measure the deflection (A) , depressing the belt halfway between the fan drive pulley and alternator pulley at specified force 98 N (10 kgf, 22 lbf). 2. If the measurement is not within the factory specifications, loosen the alternator mounting screws and relocate the alternator to adjust. (A) Deflection W10356670 S-24 KiSC issued 07, 2008 A Engine oil pressure At idle speed Factory spec. More than 98 kPa 1.0 kgf/cm2 14 psi Allowable limit 50 kPa 0.5 kgf/cm2 7 psi At rated speed Factory spec.
300 to 440 kPa 3.0 to 4.5 kgf/cm2 43 to 64 psi Allowable limit 250 kPa 2.5 kgf/cm2 36 psi Tightening torque Oil pressure switch 15 to 19 N·m 1.5 to 2.0 kgf·m 11 to 14 lbf·ft Deflection (A) Factory spec. 7.0 to 9.0 mm 0.28 to 0.35 in.